Need Help Error: Mount [data] failed PartType: LINUX

Setting interface to EasyJtag2/ISP_HiPower
Setting bus width to 1 Bit
HiPower mode is ON
Setting frequence to 12 Mhz
CMD Pullup Level: 1712 mV
CMD Active Level: 1853 mV
EMMC Device Information :
EMMC CID: 90014A4841473265050756718C9BC289
EMMC CSD: D02701320F5903FFFFFFFFEF8A4040D3
EMMC Manufacture : SKHYNIX , EMMC NAME: HAG2e , HEX: 484147326500 , S/N: 56718C9B , rev. 0x07
EMMC Manufacture ID: 0x90 , OEM ID: 0x4A , Device Type: BGA (Discrete embedded) , Date: 12/2015
EMMC ROM 1 (Main User Data) Capacity: 15032 MB (0003AB800000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 4096 KB (000000400000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 4096 KB (000000400000)
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.7 (MMC 5.0, MMC 5.01)
Boot configuration [PARTITION_CONFIG]: 0x38 , Boot from: ROM1 (Main User Area)
Boot Bus Config: 0x00 , width 1bit
H/W Reset Function [RST_N_FUNCTION]: 0x01, RST_n signal is permanently enabled
Supported partition features [PARTITIONING_SUPPORT]: 0x07
Device supports partitioning features
Device can have enhanced technological features in partitions and user data area
Device can have extended partitions attribute
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: HAG2e_56718C9B_20181108_160044.extcsd
EMMC Init completed.

Get firmware version

Error: Mount [data] failed PartType: LINUX
Brand = YU
Manufacturer = YU
Model = YU5510A
Phone platform = msm8916
CPU Abi = arm64-v8a
Android release = 5.1.1
Firmware version = 5.1.111.P0.160314.YU5510A
Firmware date = Sat Jun 4 15:30:59 CST 2016