before was logo problem
flash after dead
this is log
11/13/2018 11:13:17 PM> Looking for EasyJTAG box...
11/13/2018 11:13:17 PM> EasyJTAG API ver. 2100
11/13/2018 11:13:17 PM> Setting IO Levels to 2.8V
11/13/2018 11:13:17 PM> Setting frequence to 21 Mhz
11/13/2018 11:13:17 PM> EasyJTAG Box Serial = 1100201C652C0BA6
11/13/2018 11:13:17 PM> EasyJTAG Box Firmware = 1.63
11/13/2018 11:13:18 PM> Setting frequence to 21 Mhz
11/13/2018 11:13:18 PM> CMD Pullup Level: 2165 mV
11/13/2018 11:13:18 PM> CMD Active Level: 2732 mV
11/13/2018 11:13:18 PM> eMMC Init returned = 0
11/13/2018 11:13:18 PM> EMMC Device Information :
11/13/2018 11:13:18 PM> EMMC CID: 90014A483447326211016033510EA2D6
11/13/2018 11:13:18 PM> EMMC CSD: D07F01320F5903FFFFFFFFEF8A4040DA
11/13/2018 11:13:18 PM> EMMC Manufacture : SKHYNIX , EMMC NAME: H4G2b , HEX: 483447326200 , S/N: 6033510E , rev. 0x01
11/13/2018 11:13:18 PM> EMMC Manufacture ID: 0x90 , OEM ID: 0x4A , Device Type: BGA (Discrete embedded) , Date: 10/2015
11/13/2018 11:13:18 PM> EMMC ROM 1 (Main User Data) Capacity: 3728 MB (0000E9000000)
11/13/2018 11:13:18 PM> EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 4096 KB (000000400000)
11/13/2018 11:13:18 PM> EMMC RPMB (Replay Protected Memory Block) Capacity: 4096 KB (000000400000)
11/13/2018 11:13:18 PM> EMMC Permanent Write Protection: No
11/13/2018 11:13:18 PM> EMMC Temporary Write Protection: No
11/13/2018 11:13:18 PM> Extended CSD Information :
11/13/2018 11:13:18 PM> Extended CSD rev: 1.6 (MMC 4.5, MMC 4.51)
11/13/2018 11:13:18 PM> Boot configuration [PARTITION_CONFIG]: 0x08 , Boot from: ROM2 (Boot partition 1)
11/13/2018 11:13:18 PM> Boot Bus Config: 0x00 , width 1bit
11/13/2018 11:13:18 PM> H/W Reset Function [RST_N_FUNCTION]: 0x00, RST_n signal is temporarily disabled
11/13/2018 11:13:18 PM> Supported partition features [PARTITIONING_SUPPORT]: 0x07
11/13/2018 11:13:18 PM> Device supports partitioning features
11/13/2018 11:13:18 PM> Device can have enhanced technological features in partitions and user data area
11/13/2018 11:13:18 PM> Device can have extended partitions attribute
11/13/2018 11:13:18 PM> Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
11/13/2018 11:13:18 PM> Backup saved: H4G2b_6033510E_20181113_231318.extcsd
11/13/2018 11:13:18 PM> EMMC Init completed.
11/13/2018 11:13:18 PM>
11/13/2018 11:13:18 PM> Operation: Write by vendor (Samsung)
11/13/2018 11:13:18 PM>
11/13/2018 11:13:18 PM> Creating GPT-partitioninig
11/13/2018 11:13:18 PM> Writing PrimaryGPT at address: 000000000000
11/13/2018 11:13:19 PM> Error writing at address: 000000000000 , error: 34 , 34 Unknown error ... Retry #1
11/13/2018 11:13:19 PM> Error writing at address: 000000000000 , error: 34 , 34 Unknown error ... Retry #2
11/13/2018 11:13:19 PM> Error writing at address: 000000000000 , error: 34 , 34 Unknown error ... Retry #3
11/13/2018 11:13:20 PM> Too many errors. Writing has been stopped
11/13/2018 11:13:20 PM>
