Frp samsung j737v 8.0.0 binary 2

1- flash binary combination 2 download from z3x support (with THIS ENABLE OEM)

2- when turn on, go adjust and activate OEM

3- turn off the equipment

4- then put it in download mode, you will see that it says FRP off

5- Finally, full binary flash 2 in my case, I installed the same as I had.

Operation: Flash


Selected model: SM-J737V
Software version: 35.3

File analysis ... OK
Total file size: 0x5C8BD1C8 (1480 Mb)
Searching USB Flash interface ... COM16 detected
Setup connection ... OK
Set PIT file ... OK
Reading PIT from phone ... OK
Sending sboot.bin ... OK
Sending param.bin ... OK
Sending cm.bin ... OK
Sending nad_fw.bin ... OK
Sending nad_refer.bin ... OK
Sending boot.img ... OK
Sending recovery.img ... OK
Sending system.img ... OK
Sending vendor.img ... OK
Sending carrier.img ... OK
Sending userdata.img ... OK
Sending modem.bin ... OK
Sending modem_debug.bin ... OK
Sending cache.img ... OK
Sending odm.img ... OK
Sending omr.img ... OK
Flashing done (time - 00:01:46)

Operation: Flash
Selected model: SM-J737V
Software version: 35.3
File analysis ... OK
Total file size: 0x1184CCE5A (4484 Mb)
Searching USB Flash interface ... COM16 detected
Setup connection ... OK
Set PIT file ... OK
Reading PIT from phone ... OK
Sending sboot.bin.lz4 ... OK
Sending param.bin.lz4 ... OK
Sending cm.bin.lz4 ... OK
Sending boot.img.lz4 ... OK
Sending recovery.img.lz4 ... OK
Sending system.img.lz4 ... OK
Sending vendor.img.lz4 ... OK
Sending carrier.img.lz4 ... OK
Sending userdata.img.lz4 ... OK
Sending modem.bin.lz4 ... OK
Sending modem_debug.bin.lz4 ... OK
Sending cache.img.lz4 ... OK
Sending odm.img.lz4 ... OK
Sending omr.img.lz4 ... OK
Flashing done (time - 00:04:20)
Done with Samsung Tool PRO v.35.3

Done with Samsung Tool PRO v.35.3