I needed to replace eMMC in N8010 ( Samsung tablet).
I flashed a new eMMC ( via Easy Jtag )and then I soldered it on the mainboard. But N8010 does not boot( no downloading mode is available).So I tried ISP connection, to check eMMC was working and it was. I can read/write data into it. Next I tried Samsung PRO Tools to flash the whole image again via Samsung Pro Tools interface but it could not ( Error was reported - flashing did not even start).
Anyone have any idea where can be a problem. How to test it?
Can it be a data lines( to eMMC) problem or port flex problem?
I flashed a new eMMC ( via Easy Jtag )and then I soldered it on the mainboard. But N8010 does not boot( no downloading mode is available).So I tried ISP connection, to check eMMC was working and it was. I can read/write data into it. Next I tried Samsung PRO Tools to flash the whole image again via Samsung Pro Tools interface but it could not ( Error was reported - flashing did not even start).
Anyone have any idea where can be a problem. How to test it?
Can it be a data lines( to eMMC) problem or port flex problem?
